-01-01.png)
Serial Connection
Connect a straight through 9-pin DB male-to-female cable between the J6 RESULTS PORT on the Omnisport 2000 console and a serial port on the computer with the Meet Manger software. A USB-to-serial adapter may be needed.
Omnisport 2000 Console Setup
To configure the console, press [Menu]>[4]>[4]>[3]. Verify that the right LCD displays RSLT: OMNI 2000 on line 2. If it does not, press [→] until it appears, then press [Enter].
***NOTE: If using an Omnisport 2000e with network capability, make sure that the network is disabled.***
Press [MENU]>[4]>[7]>[1]>[Down Arrow/NEXT] till "Network: OFF" displays>[ENTER] then [MENU] to escape.
MEET MANAGER Timing Console Interface Setup
1. From the main menu of MEET MANAGER, go to Set-up > Timing Console INTERFACE
2. In the Timer Vendor window, select Daktronics Omnisport 2000.
3. Under Connection Method- Omnisport 2000 Only, select Serial Port or USB to Serial.
4. Click OK to save the settings.
MEET MANAGER & Omnisport 2000 Communication
1. From the main menu of MEET MANAGER, click Run.
2. In the Run the Meet window, go to Interfaces > Timer (DAK2) > Open/Close Serial Port for DAK2
3. In the Select Serial Port for Daktronics Omnisport 2000 window, enter the Serial Com Port that will be used to connect MEET MANAGER to the Omnisport 2000 (typically 1) and click OK.
4. Go to Interfaces > Timer (DAK2) > Test Communication with DAK2. If all connections and configurations are correct, the Communications Passed message appears with the version of firmware in the Omnisport 2000 console. Click OK
Downloading Event Lists to Omnisport 2000
When downloading an Event List, make sure that the Omnisport 2000 console is in Swimming mode and that the running time is reset.
1. From the main menu of MEET MANAGER, click Run.
2. In the Run the Meet window, go to Interfaces > Timer (DAK2) > Download Events to DAK2.
3. The following message will appear. As long as the correct events are listed, click Yes.
4. After the Event List has successfully transferred to the console, the following message will appear. Click OK.
