-01-01.png)
The default setting is that the recall is enabled. It is uncommon to disable the recall.
Enable or Disable Recall
1. Plug the handheld microphone directly into the MIC jack on the HS-200.
2. To access the setup mode, turn the power switch to ON. Immediately after the BATTERY FULL and BATTERY LOW LEDs flash, press the PUSH TO TALK lever three times.
3. The four LED indicators on the horn start will flash and the speaker will sound a warbling tone when the Recall On setting is active. If that setting is not active, then no sound will come from the speaker and the four LED indicators will flash.
4. To change the setting, press the PUSH TO TALK button once. This will enable or disable the setting. 5. To save the current setting, press and hold the PUSH TO TALK button while pressing the top button twice. The LEDs should stop flashing. The HS-200 horn start is now configured for the selected recall setting.